Simplified acquisition threshold and micro-purchases
Updated Nov 19, 2026
The micro-purchase threshold (MPT) and the simplified acquisition threshold (SAT) are dollar lines in federal buying. Below them, the government uses lighter, faster rules. As read in FAR 2.101 on acquisition.gov on 20 Nov 2026, the base MPT is $15,000 and the base SAT is $350,000. Both have exceptions, and both get adjusted over time.
The two thresholds
| Threshold | Base amount (FAR 2.101, read 20 Nov 2026) |
|---|---|
| Micro-purchase threshold | $15,000 |
| Simplified acquisition threshold | $350,000 |
FAR 2.101 also lists higher or lower amounts for particular cases. Examples from the page: a lower micro-purchase threshold for some construction and for services under the Service Contract Labor Standards, and higher thresholds for certain contingency, disaster and emergency purchases. If your work falls in a special category, read the definition and the notice. Do not assume the base number applies.
Check the live page before relying on any figure. The FAR is updated through Federal Acquisition Circulars, and dollar thresholds have changed before.
What a micro-purchase is
Purchases at or under the MPT can be made with very little process. Often the buyer uses a government purchase card and does not have to solicit multiple quotes if the price is considered reasonable. Many of these are never posted publicly. They are bought through supply schedules, catalogs, or by simply calling vendors. To be considered, vendors usually need to be visible: registered in SAM.gov, listed on schedules or on state and local vendor lists, and known to the buying office.
What the simplified acquisition threshold means
Purchases above the MPT and up to the SAT may use simplified acquisition procedures, designed to be faster than a full competition. Commonly:
- Quotes can be requested from a few vendors, and notices may be short.
- Response times are set by the contracting officer as reasonable. FAR 5.203 says the 30-day minimum response period does not apply to actions at or below the SAT.
- FAR 19.502-2 sets the default that purchases between the MPT and SAT are reserved for small business when the contracting officer reasonably expects offers from at least two responsible small businesses, with exceptions.
Those last two points make this range friendly to small firms: shorter paperwork and a better chance the competition is limited to small businesses.
Why it matters for you
- Smaller buys are a good first target. Lower dollar value, less paperwork, and often fewer bidders.
- Deadlines can be short. Notices at this level may give you days, not weeks. BidCamel shows the typical response window per buying office.
- Registration matters. Without an active SAM.gov registration you may be passed over. See lesson 2.
- Check the notice for the rules. The thresholds tell you the likely process, not the final one.
Steps
- Look up the current thresholds in FAR 2.101.
- Search for notices in your NAICS code under $350,000 using BidCamel search.
- Check each notice for set-aside and due date.
- Compare to past awards in awards to see typical sizes.
General information, not legal advice.
Use BidCamel search to find small notices in your NAICS code and check the buying office’s usual response window.